是否可以将PWM块分配给多个输出

这可以很容易与各种各样的资源。PWM可以连接到输出row2为例，利用相邻两输出interconnects2 1。使用输出第一行互连和打开所有输出驱动器并选择输入B（第2行）使用输出interconnectrow和打开所有输出驱动器。现在你会用相同的PWM信号有8全球输出列。这些现在可以连接到8个输出引脚使用端口0和端口1（四从每个端口）。
或者你可以只使用4全球输出列和使用从四端口引脚来完成同样的事情或选择只有偶数端口，你可以通过只使用全球输出。这是最后一个例子。
发光二极管可以打开和关闭通过外部信号从另一端的LED或通过软件关闭输出驱动器。
CY8C24794.ZIP
16.5 K



     以下为原文
  This can be done fairly easily and with a wide variety of resources.  The PWM can be connected to output row 2 for example, then use two adjacent output interconnects 2 and 1. Use output row 1 interconnect and turn on all ouput drivers and select input B (row 2) use the output interconnect Row 2 and turn on all output drivers.  You will now have 8 Global output columns with the same PWM signal.  These can now be hooked up to 8 output pins using Ports 0 and 1 (four from each port).
    Alternately you could use only four global output columns and use 2 pins from 4 ports to accomplish the same thing or by selecting only even numbered ports, you can get by with only using 4 global outputs.  Here is an example of the last.
    The LEDs can then be turned on and off by external signals from the other end of the LED or by software turning off the output driver.

•   CY8C24794.zip 16.5 K