如何用滑动载荷定义波导校准套件？

据我所知，安捷伦波导校准套件中没有一个包含滑动负载。
我正在尝试找出最佳/最简单的方法来定义具有以下特性的波导校准套件* lamba / 8偏移短* 3 * lamba / 8偏移短*滑动负载。
我怀疑试图修改最简单的套件会很困难，但以下*可能*工作并且是最无痛的方式。
1）从85052B开始，这是一个带滑动负载的3.5 mm套件。
（与85054B N-kit不同，3.5 mm套件上男性和女性的系数相同）2）将短路的偏移延迟修改为3 * lambda / 8短路的偏移延迟3）修改偏移
延迟的开放是lambda / 8的偏移延迟4）更改名称“SHORT”＆amp;
“OPEN”至“3/8 SHORT”和“1/8 SHORT”5）将校准类型设置为波导6）将阻抗设置为1 Ohm 7）设置波导的截止频率。
我想在8720D上这样做。
谁能建议最好的方法？
PS，8720系列文件仍不适合X11644A。
戴夫



     以下为原文

  As far as I am aware, none of the Agilent waveguide calibration kits include a sliding load. I am trying to work out the best/easiest way to define a waveguide cal kit that has the following properties  

* lamba/8 offset short
* 3*lamba/8 offset short
* sliding load.  

I suspect that trying to modify the simplest kit would be a struggle, but the following *might* work and be the most painless way.  

1) Start with an 85052B, which is 3.5 mm kit with sliding loads. (Unlike the 85054B N-kit, the coefficients are the same for males and females on the 3.5 mm kit)
2) Modify the offset delay of an short to be the offset delay of the 3*lambda/8 short
3) Modify the offset delay of the open to be be offset delay of the lambda/8
4) Change names of "SHORT" & "OPEN" to "3/8 SHORT" and "1/8 SHORT"  
5) Set calibration type to waveguide
6) Set impedance to 1 Ohm
7) Set the cutoff frequency of the waveguide.  

I want to do this on an 8720D.  

Can anyone suggest the best way?  

PS, the 8720 series files are still not right for the X11644A.  

Dave