PSoC5中的UART没有出现在终端

你好，
我刚刚开始用开发工具CY8CKIT-050对PSoC5进行评估。
我打开了ADCYDAC示例应用程序，该应用程序在LCD上显示一个8位的POT位置。IOW想把这个值通过RS232以二进制方式传送到终端应用程序。于是我抓起一个UART，把它丢在我的床单上，想象了BaDeRead，Stand和Posiple并添加了UARTHARtiVE（），然后UARTURL PATSHIPE（Hello World！rn）；之后。然而，当Ireset我的开发工具包，没有出现在终端。
在原理图设计中，RX和TX引脚自动地连接到RXY1和TXY1，假设是RX和Tx，它们被路由到9PIN D子连接器。
任何提示都将不胜感激，谢谢！
罗恩



     以下为原文
  Hi There,
     
    I'm just starting evaluation of PSoC5 with the Development Kit CY8CKIT-050.
    I opened the ADC_DAC sample application that displays an 8bit pot position on the LCD. I now would like to communicate this value in binary over RS232 to a terminal application. So I grabbed a UART and dropped it on my sheet, I configured baudrate, stopbit and parity and added UART_Start(); and then UART_PutString("Hello World!rn"); after that. However, when I reset my dev kit, nothing appears in the terminal.
    On the schematic design, the rx and tx pins were automatically wired up to Rx_1 and Tx_1 which I assume are the Rx and Tx that are routed to the 9pin d-sub connector .
     
    Any hints would be appreciated, Thank you!
    Ron