ICD4配置位的无效组合

您好，我想用一个PIC32 MX575 F512L在现有项目中使用ICD4而不是ICD3。这个项目用ICD3调试没有问题。用ICD4，从“调试项目”图标开始，我在ICD4窗口中得到以下错误：PLAB ICD 4…当前加载版本：应用程序版本….01.02.16BooD版本…01.00 .00 FPGA版本….01.00 .00脚本版本….00 .02.23脚本构建号….45 A591CBC0应用程序构建号…012345 67 89-目标电压检测器DPAST设备PIC32 MX55F512L发现。设备ID修订= 0xA5Error…下面的内存区域将被编程：程序存储器：起始地址＝0x1D08000，结束地址＝0x1D08FFFAST内存：起始地址＝0x1D9009000，结束地址＝0x1D064 FFFFACtiON内存启动配置文件TreWreDebug向量用状态类型＝RunScript失败，脚本名称＝WrreDebug Gebug，状态＝0x102。无法进入调试模式，因为编程调试信息失败。配置位的无效组合可能导致这个问题，如：是否可以用ICD3和ICD4调试相同的设置项目？



      以下为原文

    Hello,
I want to use the ICD4 instead of ICD3 in an existing project with a PIC32MX575F512L.
The debugging of this project with ICD3 works without problems.

With ICD4, after start with the "Debug Project" icon, I got the following error in the ICD4 window:
###############################
Connecting to MPLAB ICD 4...
Currently loaded versions:
Application version............01.02.16
Boot version...................01.00.00
FPGA version...................01.00.00
Script version.................00.02.23
Script build number............45a591cbc0
Application build number.......0123456789
Target voltage detected
Target device PIC32MX575F512L found.
Device Id Revision = 0xA5
Erasing...
The following memory area(s) will be programmed:
program memory: start address = 0x1d008000, end address = 0x1d0087ff
program memory: start address = 0x1d009000, end address = 0x1d064fff
configuration memory
boot config memory
Script WriteDebugVector failed with status Type = runScript, Script name = WriteDebugVector, Status = 0x102
.
Could not enter debug mode because programming the debug information failed. Invalid combinations of config bits may cause this problem
###############################
Which config bits have to change ?
Is it possible to debug the project with the same settings with ICD3 and ICD4 ?