HP 11713A衰减器/开关驱动器的问题

我刚买了一台HP11713A ATTENUATOR / SWITCH DRIVER和2个可编程步进衰减器（8494H和8496H）我可以使用直接i / o并发送那些字符串如“A12B5678”并让衰减器垫打开/关闭。问：是
有一个仪器驱动程序，这样你就可以发送一个十进制数，如63，并将重点配置为63dB？-dan k.san diegoDan K.'92 Gray Dak CC，318,4x2,46RH，3.55后，
235 / 75R15，PS，PW，PB，PL，AC。模式：冷空气，K＆amp; N油/空气，180 * T-Stat，Autolite 3924s，重新定位IAT，Trans-Go换档套件。未来：交换电机
对于略微修改的Magnum 5.9L引擎.


     以下为原文

  
I just got a HP11713A ATTENUATOR/SWITCH DRIVER and 2 programmable step attenuators (
8494H and 8496H )


I can use direct i/o and send those strings of charactors such as "A12B5678"  and get the
attenuator pads to switch on/off.

Q:   Is there an instrument driver for this so that you can send a decimal number, like
63, and have the attenuoator re-configured for 63dB?

-dan k.
san diego

Dan K.
'92 Grey Dak CC, 318, 4x2, 46RH, 3.55 rear, 235/75R15, PS, PW, PB, PL, AC.

Mods:  Cool air,  K&N oil/air,  180* T-Stat,  Autolite 3924s, re-located IAT,  Trans-Go shift kit.

Future:  Swap motor for a slightly modified Magnum 5.9L engine.