如何使用信号室建立脉冲连接到N8241A？

嗨，我正在尝试使用Signal Studio进行脉冲构建，以连接到N8241A宽带Arb和E8267D矢量信号发生器。
使用系统配置向导，我可以连接到E8267D ok了，但是当我尝试连接到N8241A，它使用命令“TCPIP0 :: 192.168.1.101 :: 4000 :: SOCKET”，这将失败。
当我使用Agilent Connection Expert时，我可以很好地连接到N8241A，因为它使用命令“TCPIP0 :: 192.168.1.101 :: inst0 :: INSTR”。
在系统CONFIGRATION向导，我试图选择“从IO库配置的接口列表中选择一个外部宽带任意波”，我可以看到选择“TCPIP0 :: 192.168.1.101 :: inst0 :: INSTR”，但脉冲大厦去
前进并发出命令“TCPIP0 :: 192.168.1.101 :: 4000 :: SOCKET”无论如何。我正在使用Pulse Building版本1.2.28（我也尝试过1.3.25）和Agilent IO Libraries版本15.0。
我试过没有运气就卸载并重新安装所有相关的软件。奇怪的是，这个相同的配置适用于另外两台笔记本电脑。
在这种情况下，该软件几年前就安装了。
我不明白是什么迫使Pulse Building发出“SOCKET”命令，或者我如何改变它。任何帮助都表示赞赏。谢谢，迈克



     以下为原文

  Hi,

I am trying to use Signal Studio for Pulse Building to connect to the N8241A Wideband Arb and E8267D Vector Signal Generator.  Using the System Configuration Wizard, I can connect to the E8267D ok, but when I try to connect to the N8241A, it uses the command "TCPIP0::192.168.1.101::4000::SOCKET", which fails.  When I use the Agilent Connection Expert, I can connect to the N8241A just fine, because it uses the command "TCPIP0::192.168.1.101::inst0::INSTR".  In the System Configration Wizard, I tried to select "Choose an External Wideband Arb from list of configured interfaces in IO libraries", I can see the selection "TCPIP0::192.168.1.101::inst0::INSTR", but Pulse Building goes ahead and issues the command "TCPIP0::192.168.1.101::4000::SOCKET" anyway.

I am using Pulse Building version 1.2.28 (I have also tried 1.3.25), and Agilent IO Libraries version 15.0.  I have tried uninstalling and reinstalling all relevant software without luck.

The strange thing is that this same configuration works on two other laptops.  In this case, the software was installed several years ago.  I don't understand what is forcing Pulse Building to issue the "SOCKET" command, or how I can change it.

Any assistance appreciated.

Thanks,
Mike