内部连接到TEMAC时，以太网1000BASE-X中的GMII配置怎么处理

嗨Huppa，
当内部连接到TEMAC时，以下链接中讨论的内容也适用于1000Base_X内核。
http://forums.xilinx.com/t5/General-Technical-Discussion/Tri-mode-Ethernet-MAC-with-Internal-PHY-interface/m-p/486850#M19280
不需要IODELAY，IOB或弹性缓冲区，两个核心应直接通过GMII接口连接，如下图所示。
问候，萨蒂什-----------------------------------------------
--- --------------------------------------------请注意
- 如果提供的信息有用，请将答案标记为“接受为解决方案”。给予您认为有用的帖子。感谢.--
---------------------------- ---------------------
----------------------
在原帖中查看解决方案



以下为原文

Hi Huppa,
 
 
The same things  as discussed in the below link apply to 1000Base_X core as well when internally  connected to TEMAC.
 
http://forums.xilinx.com/t5/General-Technical-Discussion/Tri-mode-Ethernet-MAC-with-Internal-PHY-interface/m-p/486850#M19280
 
There is no need of IODELAY,IOB's or the elastic buffer and the two cores should be connected directly through the GMII interface as shown in below snapshot.
 

Regards,

Satish

--------------------------------------------------​--------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful.
--------------------------------------------------​-------------------------------------------View solution in original post

嗨Huppa，
当内部连接到TEMAC时，以下链接中讨论的内容也适用于1000Base_X内核。
http://forums.xilinx.com/t5/General-Technical-Discussion/Tri-mode-Ethernet-MAC-with-Internal-PHY-interface/m-p/486850#M19280
不需要IODELAY，IOB或弹性缓冲区，两个核心应直接通过GMII接口连接，如下图所示。
问候，萨蒂什-----------------------------------------------
--- --------------------------------------------请注意
- 如果提供的信息有用，请将答案标记为“接受为解决方案”。给予您认为有用的帖子。感谢.--
---------------------------- ---------------------
----------------------



以下为原文

Hi Huppa,
 
 
The same things  as discussed in the below link apply to 1000Base_X core as well when internally  connected to TEMAC.
 
http://forums.xilinx.com/t5/General-Technical-Discussion/Tri-mode-Ethernet-MAC-with-Internal-PHY-interface/m-p/486850#M19280
 
There is no need of IODELAY,IOB's or the elastic buffer and the two cores should be connected directly through the GMII interface as shown in below snapshot.
 

Regards,

Satish

--------------------------------------------------​--------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful.
--------------------------------------------------​-------------------------------------------

嗨，
最后，我已经完成了。
谢谢你的指导。



以下为原文

Hi,
 
Finally, I HAVE DONE IT.
Thanks for your guidance.