PSoC Creator中的明显错误：多个构建导致崩溃

我一直在开发PSoC Creator 4.1和CY8CKIT-04942XX原型套件。在我构建了我的小程序大约10次之后，我得到了一组错误：
“数据将不适用于区域ROM”
“……”重叠部分：加载在lnnim＆gt上的数据；
和
“构建错误：溢出0字节的区域ROM”
为了纠正这一点，我清理程序，但这会导致BooTo加载组件失效，因此我必须删除可引导加载的组件，重新构建，重新加载BooLoad组件，然后将其设置为正确的HEX文件。这个过程允许我再次重建程序。（这与我在原始程序中所做的任何琐碎的编辑无关。）
然后，当我尝试用Bootloader主机下载程序时，又遇到了另一个问题：“Flash行对于所选数组无效。”有时我可以通过关闭PSoC Creator并重新启动来纠正最后一个问题。最近，甚至没有效果。我目前无法使用Bootloader宿主模式来对原型工具包进行编程。（是的，我按下了按钮。）
（我目前使用MixPrim3将我的程序加载到原型工具包中。）
这是PSOoC Creator的错误吗？我不知道我可以做什么错误，导致程序不建立，也不知道为什么我必须重新安装BootloadLead组件后，干净，也不为什么引导装载主机不再工作。
这个问题在我的两个原型工具包上都是相同的。
如有任何意见，将不胜感激。谢谢您。



     以下为原文
  I have been developing with PSoC Creator 4.1 and the CY8CKIT-049-42xx prototyping kit. After I build my very small program about 10 times I get a group of errors:
    "data will not fit in region rom"
    "... overlaps section .data loaded at "
    and
    "Build error: region rom overflowed by 0 bytes"
     
    To correct this I clean the program, but that causes the bootloadable component to become invalid so I have to remove the bootloadable component, rebuild, load in the bootloadable component again and then set it to the correct hex file. This process allows me to rebuild the program again. (None of this has anything to do with any trivial edits I may have made in my original program.)
    Then I have been getting another problem when I try to download the program with the Bootloader Host:"Flash row is not valid for the selected array." Sometimes I have been able to correct this last problem by shutting down PSoC Creator and restarting. Lately, not even that works. I am currently unable to use the Bootloader host mode to program the prototyping kit. (Yes, I held the button down.)
    (I am currently using the miniprog3 to load my programs on to the prototyping kit.)
    Is this a bug with PSOoC Creator? I have no idea what I could be doing wrong to cause the program to not build, nor why I have to reinstall the bootloadable component after a clean, nor why the bootloader host is no longer working.
    The problem is identical on both prototyping kits that I have.
    Any advice will be greatly appreciated. Thank you.