核心变得无效

大家好，
我正在使用SPC560B54L5发现板和SPC5studio版本5.2.1以及UDE 4.2版本。设置工作正常，直到这个时间。突然间它开始提出问题。
最初，当我连接电路板时，PLS驱动程序在设备管理器中被检测到，我可以打开UDE并加载代码。但是如果我检查设备管理器PLS驱动程序是否已卸载，则在2或3分钟内核心将变为非活动状态。再次如果我断开并重新连接硬件的东西工作正常2分钟，问题再次发生。
我尝试重新安装UDE / PLS和USB驱动程序，但问题不断重复。
请提供您的建议是解决问题
提前致谢，
带着敬意，
R.santhamurthy



以下为原文




Hello All,
I am using SPC560B54L5 discovery board and SPC5studio version 5.2.1 along with UDE 4.2 version.The setup was working fine till this time. suddenly it started giving issues.
Initially when I connect the board the PLS driver is getting detected in device manager and I can able to open the UDE and load the code. But within 2 or 3 minutes the core is getting inactive later if I check the Device manager PLS driver was unmounted. Again If I disconnect and reconnect the hardware things works fine for 2 minutes and the problem occurs again.
I tried reinstalling the UDE/PLS and USB drivers but the issue keeps repeating.
Kindly provide your suggestion is resolving the issue
Thanks in Advance,
With Regards,
R.santhamurthy