MB95F118AS程序提取和编程

你好，
我需要一些技术帮助编程/阅读一个M95F118AS。
我有一个Mb95F118AS，它有已知的吹针，所以我试着从它上面读取程序代码，把它放在一个新的空白芯片上。
我已经从HTTP://www. CyPr.com文件/软件和DealVals/Flash -MCU程序员1下载了“Flash MCU程序员程序F2MC-8FX”，但是程序只有一个M95F118B/M目标微控制器。我看不懂芯片。
在不设置MOD引脚浮动的情况下，我正在从处理器获得数据，所以处理器是活的，并且连接到它的4MHz晶体正在工作。
通过将MOD引脚设置为高，处理器处于编程状态（我猜）——但是当我点击软件上的下载时，它不会响应。
我还设置P12/KK到高和P13至低的编程指南。
请问我使用的软件是否正确？或者如果我做错了什么？
谢谢您，
加布里埃尔青年
26905830191015985017910744194924911o.jPG
80 K
269097 901 10156985 14923 575 4 42626728 41IO JPG
84.4 K
连接故障
41.3 K
DSC02680.JPG
324.3 K



     以下为原文
  Hi,

I need some technical help with programming/reading a MB95F118AS.  

I have a MB95F118AS Which has known blown pins so I am trying to read the program code off of it to put onto a new blank chip I have.  
I have downloaded the “FLASH MCU Programmer for F2MC-8FX” From http://www.cypress.com/documentation/software-and-drivers/flash-mcu-programmer-1 but the program only have a MB95F118B/M target Microcontroller.  I am unable to read the chip.  

Without setting the MOD pin floating, I am getting data from the processor so the processor is alive and the 4MHz Crystal connected to it is working.
With setting the MOD pin to HIGH the processor sits in the programming state (I guess) – But when I click download on the software it does not respond.
I have also set P12/UCK to High and P13 to LOW as per the programming guide.


Can you please advise if the software I am using is correct? Or if there is something I'm doing wrong?

Thank You,
Gabriel Young

•    26905830_10156985017910744_1949249391_o.jpg 80.0 K
•   26909790_10156985149235744_267472841_o.jpg 84.4 K
•   connectfail.PNG 41.3 K
•   DSC02680.JPG 324.3 K