为什么Motor Profiler不支持STEVAL-SPIN3202/3201板？

我看到一个帖子，他们说F0只是不够强大，无法运行探查器。只有F3及以上



以下为原文




I saw a post they say F0 just not powerful enough to run the profiler. Only F3 and up

感谢回复，Diandi！
这也是我的想法，
如果您在STSW-SPIN3201中编译示例项目，
闪光灯和内存几乎100％被利用！



以下为原文




Thanks for reply, Diandi!
That's what I think too,
for if you compile the sample project in STSW-SPIN3201,
the flash and ram are almost 100% utilized!

我遇到了同样的问题。一开始我尝试生成一个trueStudio项目，使用'-o3'优化编译。代码大小小于32k，但它没有（我在指出TrueStudio中不支持F0的hal库之后读了一篇文章。我不知道这是不是问题。而且我也试过LL驱动程序没有运气）所以我切换到keil（你可以获得f0的免费许可），现在编译的代码大小约为23k，只启用了霍尔传感器。
我在这里有关于代码大小的帖子：
https://community.st.com/0D50X00009XkW99SAF
 
 注意：原始帖子包含大量线程对话，只能迁移到第9级



以下为原文




I encountered the same problem. At beginning I tried to generate a trueStudio project, compiled with '-o3' optimization on. The code size is less than 32k but it didn't(I read a post after pointing out that the hal library for F0 is not supported in TrueStudio yet. I don't know if that's the problem. And I also tried LL driver with no luck) So I switched to keil(you can get free license for f0), now the compiled code size is about 23k with only hall sensor enabled.
I have a post about code size here:

https://community.st.com/0D50X00009XkW99SAF
  
Note: the original post contained a large number of threaded conversations and was only able to be migrated to the 9th level

亲爱的大家，
你是对的，F0不够强大，无法进行分析。主要原因是没有FPU是强制性的。
问候
塞德里克



以下为原文

Dear all,
You are right, F0 is not powerful enough to do profiling. The main reason is that there is no FPU which is mandatory.
Regards
Cedric