在SPC56EL70L5上执行TEST应用程序出现错误

嗨，

我开始使用通过PC连接的SPC56L-Discovery板
SPC5-UDESTK jtag-u***适配器。我安装了SPC5Studio和UDE 4.0来调试我的电路板并在其上加载程序。
但是，按照文档AN4321的步骤，我发现了一个“奇怪的”错误 从SPC56LDiscovery开始。事实上，当我生成并编译应用程序时，一切都很顺利，但是当我尝试调试它时（并自动打开UDE）我有这个错误：

- 来自组件'PpcJtagTargIntf'的消息：
无法连接目标！

来自组件'PpcJtagTargIntf'的消息：


来自组件'PpcJtagTargIntf'的消息：
找不到JTAG客户端！
请检查：
  - 目标电源
  - JTAG电缆连接
  - 目标配置

来自组件'UDEDebugServer'的消息：
无法建立连接。要更正此情况，请检查配置文件条目，然后重试。

有人可以帮帮我吗？我不知道我能做什么。
谢谢大家
#hightec



以下为原文




Hi,

I'm starting to use a SPC56L-Discovery board that I connect with the PC through
the SPC5-UDESTK jtag-u*** adapter. I installed the SPC5Studio and the UDE 4.0 to debug my board and load programs on it.
But I have a ''strange'' error following the steps of the document AN4321 �Getting started with the SPC56LDiscovery�. In fact, all goes perfectly when I generate and compile the application, but when I try to debug it (and automatically it opens the UDE) I have this error:

-Message from component 'PpcJtagTargIntf' :
Can't connect target !

Message from component 'PpcJtagTargIntf' :


Message from component 'PpcJtagTargIntf' :
No JTAG client found !
Please check:
- target power supply
- JTAG cable connection
- target configuration

Message from component 'UDEDebugServer' :
Unable to establish connection . To correct the situation, check configuration file entries and try again.

Someone could help me? I don't know what I can do.
Thanks to all  
#hightec