为什么定时器会在stm32进行启动文件配置的时候进入中断了？

为什么定时器会在STM32进行启动文件配置的时候进入中断了，场景是重新烧录代码之后就出现，如果烧录前擦除下flash就不会出现此情况，看寄存器在此阶段并未复位。
软件环境为STM32Cubeide+openOCD
static void MX_TIM1_Init(void){  /* USER CODE BEGIN TIM1_Init 0 */  /* USER CODE END TIM1_Init 0 */  TIM_ClockConfigTypeDef sClockSourceConfig = {0};  TIM_MasterConfigTypeDef sMasterConfig = {0};  /* USER CODE BEGIN TIM1_Init 1 */  /* USER CODE END TIM1_Init 1 */  htim1.Instance = TIM1;  htim1.Init.Prescaler = 239;  htim1.Init.CounterMode = TIM_COUNTERMODE_UP;  htim1.Init.Period = 99;  htim1.Init.ClockDivision = TIM_CLOCKDIVISION_DIV1;  htim1.Init.RepetitionCounter = 0;  htim1.Init.AutoReloadPreload = TIM_AUTORELOAD_PRELOAD_ENABLE;  if (HAL_TIM_Base_Init(&htim1) != HAL_OK)  {    Error_Handler();  }  sClockSourceConfig.ClockSource = TIM_CLOCKSOURCE_INTERNAL;  if (HAL_TIM_ConfigClockSource(&htim1, &sClockSourceConfig) != HAL_OK)  {    Error_Handler();  }  sMasterConfig.MasterOutputTrigger = TIM_TRGO_RESET;  sMasterConfig.MasterOutputTrigger2 = TIM_TRGO2_RESET;  sMasterConfig.MasterSlaveMode = TIM_MASTERSLAVEMODE_DISABLE;  if (HAL_TIMEx_MasterConfigSynchronization(&htim1, &sMasterConfig) != HAL_OK)  {    Error_Handler();  }  /* USER CODE BEGIN TIM1_Init 2 */  /* USER CODE END TIM1_Init 2 */}