您好，这表示防护8051处理器没有正确响应Inguard处理器尝试在PON与它通信。
从这个，我猜你不能通过GPIB或RS232与盒子通信？
假设是这种情况，它可能有很多东西：处理器本身，XG光隔离器，OG电源等。这将是相当多的故障排除。
你最好把设备送去维修或换货，对不起。
以上来自于谷歌翻译
以下为原文
Hello,
This indicates that the outguard 8051 processor did not respond properly to the Inguard processor’s attempt to communicate with it at PON. From this, I would guess that you cannot communicate with the box over GPIB or RS232? Assuming that’s the case, there’s a lot of things it could be: the processor itself, the XG opto isolators, the OG power supply, etc. It would be quite a bit of troubleshooting.
Your better off sending the unit in for repair or exchange, sorry.
您好，这表示防护8051处理器没有正确响应Inguard处理器尝试在PON与它通信。
从这个，我猜你不能通过GPIB或RS232与盒子通信？
假设是这种情况，它可能有很多东西：处理器本身，XG光隔离器，OG电源等。这将是相当多的故障排除。
你最好把设备送去维修或换货，对不起。
以上来自于谷歌翻译
以下为原文
Hello,
This indicates that the outguard 8051 processor did not respond properly to the Inguard processor’s attempt to communicate with it at PON. From this, I would guess that you cannot communicate with the box over GPIB or RS232? Assuming that’s the case, there’s a lot of things it could be: the processor itself, the XG opto isolators, the OG power supply, etc. It would be quite a bit of troubleshooting.
Your better off sending the unit in for repair or exchange, sorry.
举报
