RT-thread两种方式读取到W25Q16的ID不一样是什么原因

#include "W25Q16.h"
struct rt_spi_device *spi_dev_w25q;
void W25Q16_thread()
{
__HAL_RCC_GPIOA_CLK_ENABLE();
rt_hw_spi_device_attach("spi1", W25Q_SPI_DEVICE_NAME, GPIOA, GPIO_PIN_2);
spi_dev_w25q = (struct rt_spi_device )rt_device_find(W25Q_SPI_DEVICE_NAME);
if (!spi_dev_w25q)
{
rt_kprintf("spi sample run failed! can't find %s device!\r\n", W25Q_SPI_DEVICE_NAME);
}
else
{
rt_kprintf("spi sample run success\r\n");
{
struct rt_spi_configuration cfg;
cfg.data_width = 8;
cfg.mode = RT_SPI_MODE_0 | RT_SPI_MSB; / SPI Compatible: Mode 0 and Mode 3 /
cfg.max_hz = 50 * 1000 * 1000; / 50M */
rt_spi_configure(spi_dev_w25q, &cfg);
}
rt_uint8_t w25x_read_id = 0x90;
rt_uint8_t id1[5] = {0};
rt_uint8_t w25x_read_id2[4] = {0x90,0x00,0x00,0x00};
rt_uint8_t id2[2] = {0};
rt_spi_send_then_recv(spi_dev_w25q, &w25x_read_id, 1, id1, 5);
rt_kprintf("w25q ID is:%x%x\r\n", id1[3], id1[4]);
rt_spi_send_then_recv(spi_dev_w25q, w25x_read_id2, 4, id2, 2);
rt_kprintf("w25q ID is:%x%x\r\n", id2[0], id2[1]);
}
}