如何用66319D测量冲击电流？

我正在尝试使用Agilent 66319D移动通信直流电源精确测量GSM功率放大器的突发电流。
我想触发当前的突发，然后延迟150uSec并读取下一个400uSec的平均电流。
用户手册说，只有通过编程才能使用前面板进行这种测量。
我尝试使用labview发送以下命令，因此我可以延迟触发读取，但我似乎无法获得稳定的当前读数：INIT：NAME ACQSENS：SWE：tiNT 46.8e-6; POIN 100TRIG：ACQ
：SOUR INTSENS：FUNC“CURR”TRIG：ACQ：LEV：CURR 1TRIG：ACQ：SLOP：CURR POSITIVESENS：SWE：OFFS：POIN 99然后我尝试用MEAS读取电流：CURR：HIGH？有什么东西我是吗？
我在上面的命令中做错了，还是有更好的方法来进行这种测量？



     以下为原文

  I'm trying to accurately measure the bursted current of a GSM Power Amplifier using an Agilent 66319D mobile communications DC source.  I would like to trigger on the current burst, then delay 150uSec and read the average current over the next 400uSec.  The user manual says that this type of measurement is not possible using the front panel, only through programming.  I tried sending the following commands using labview, so I can make a triggered reading with a delay, but I can't seem to get a stable current reading:

INIT:NAME ACQ
SENS:SWE:TINT 46.8e-6;POIN 100
TRIG:ACQ:SOUR INT
SENS:FUNC "CURR"
TRIG:ACQ:LEV:CURR 1
TRIG:ACQ:SLOP:CURR POSITIVE
SENS:SWE:OFFS:POIN 99

and then I try to read the current using

MEAS:CURR:HIGH?

Is there something that I'm doing wrong in the above commands, or is there a better way to make this measurement?