IDE崩溃

我有一个项目在Windows 10 /MPLAB X 3.40上工作，然后升级到3.45。当我设置断点时，IDE崩溃，没有警告或错误。最终发现论坛帖子下载了一个新的UBAccess链接。这解决了崩溃，但我的以太网链路不工作（它通过USB转换器）。最后提交了一张到Microchip的机票。一天之内他们就解决了这个问题。在试图找到错误时，我移动到一个MAC，并在MAC上安装了所有相同的组件。技术支持人员带领我完成了以太网启动器工具包II（我的硬件）的示例项目。当然，它工作得很好。然后我去了PC版本，它没有工作。我完全清除了MPLAX X从PC和重新安装V3.50。尝试重新编译并重新加载在v3.40上运行的项目，但是（等待），它在v3.50上没有工作！！！！IDE没有识别启动器套件，因此无法连接（连接失败消息）。所以我猜3.50比3.45要好，但是用新的dll比3.45差。幸运的是我可以回到我的MAC继续。问：对于MPLAB X的各种升级是否执行了SQA，或者这些MPLAB X版本都是“beta”，用户是测试人员吗？



      以下为原文

    I had a project working on Windows 10/MPLAB X 3.40, then upgraded to 3.45.  When I set a breakpoint, the IDE crashed with no warning or errors.  Eventually found the forum post to download a new USBAccessLink.dll.  That solved the crashing, but then my Ethernet link did not work (it goes through a USB converter).  Finally submitted a ticket to Microchip.  Within a day they solved the problem (sort of).  In trying to find the error, I moved to a MAC and installed all the same components on the MAC.  The tech support guy walked me through the example project for the Ethernet Starter Kit II (my hardware).  Of course, it worked perfectly.  I then went to the PC version and it did not work.  

I completely cleaned out MPLAB X from the PC and re-installed v3.50.  Tried to recompile and reload the project that worked on v3.40, and, (wait for it), it did not work on v3.50!!!  The IDE did not recognize the Starter Kit so it could not connect (Connection failed message).  So I guess 3.50 is better than 3.45 but worse than 3.45 with new dll.

Luckily I can go back to my MAC to continue.  

Q: Is there any SQA performed on the various upgrades to MPLAB X or are these MPLAB X versions all "beta" and the users are the testers?