如何使用两个E8257D获得任意相移？

*问题：*我希望在相同频率下获得两个独立的输出信号（纯正弦，无调制），它们之间具有任意相移。
如何使用下面描述的仪器设置完成此操作？
输出频率约为1 GHz。
*设置：*我可以访问两（2）个带有脉冲选项的Agilent E8257D和一个（1）外部50 MHz函数发生器（配置为输出方波）。
所有三种仪器使用相同的10 MHz参考。
函数发生器输出连接到E8257D上的脉冲输入端口，电缆长度大致相同。
*相关问题：*如果我将E8257D配置为输出非调制信号，每个仪器的E8257D输出信号是否会锁相到10 MHz参考值？
（所以，通过扩展，相互之间？）*我最初的想法：*要在两台仪器上将脉冲调制器设置为“触发延迟”，然后调整延迟。
我是在正确的轨道上吗？



     以下为原文

  *Problem:* I want to get two separate output signals (pure sine, no modulation), at the same frequency, with an arbitrary phase shift between them. How do I accomplish this with the instrument setup described below? The output frequency is about 1 GHz.

*Setup:* I have access to two (2) Agilent E8257Ds, with pulse option, and one (1) external 50 MHz function generator (configured to output a square wave). All three instruments use the same 10 MHz reference. The function generator output is connected to the pulse input ports on the E8257Ds, with approximately the same length of cable.

*Related question:* If I configure the E8257Ds to output a non-modulated signal, will the E8257D output signal from each instrument be phase-locked to the 10 MHz reference? (And so, by extension, to each other?)

*My initial idea:* To set the pulse modulator to "Triggered with delay" on both instruments, then adjust the delay.




Am I on the right track?