H3LIS331DL配置

嗨，
我正在使用H3LIS331DL传感器。我的配置如下
1传感器上的电源配置控制寄存器1具有正常功率模式和数据速率1000hz配置中断源1用于数据就绪中断GPIO回调注册数据就绪中断。这种情况工作正常。我们在获得数据就绪中断后进行采样。
我有一些特殊情况，我面临一些问题。
如果由于某些其他寄存器配置示例配置控制寄存器4而在步骤2和步骤3中存在一些延迟（在步骤2和3之间），我没有得到数据就绪中断。这是一个问题。
如果通过读取数据超过3毫秒延迟清除数据就绪中断，则下一个数据就绪中断未触发，如果获得数据就绪中断，则下一步是在步骤4之后。
你能帮助我吗？是否需要遵循顺序？
或者上述两个问题可能是什么原因。
提前致谢。
带着敬意，
Thangaraj.P



以下为原文




Hi,
I am working with H3LIS331DL sensor . my configuration is as follows

• 1Power on the sensor
• configure the control register 1 with normal power mode and data rate 1000hz
• configure interrupt source1 for data ready interrupt
• GPIO call back registered for data ready interrupt.
  

This scenario is working fine. we are sampling after getting the data ready interrupt.
I have some special cases where i am facing some issues.
if there is some delay in step 2 and step 3 due to some other register configuration example configuring the control register 4 then (in between step 2 and 3)i am not getting the data ready interrupt. This is one issue.
Next one is after step 4 if get data ready interrupt in case if i delayed to clear the data ready interrupt by reading the data for more than 3 msec then next data ready interrupt is not triggering.
could you help me is there is sequence needs to be followed?
or what could be the reason for the above 2 issues.
thanks in advance.
with Regards,
Thangaraj.P