8257D RFON状态怎么检测

Hi Cengiz-E8257D标准事件状态组寄存器位0设置为1时表示命令的最后一个操作已完成。使用以下命令查询该寄存器：* ESR该寄存器的输出是寄存器位的十进制值设置为1
如果只将位0设置为1，则输出为十进制1.如果位2（查询错误）设置为1，则输出十进制4（或者可以设置为1的所有位的十进制和）。
此信息在Agilent Technologies信号发生器编程指南N5180-90005，2009年1月第167页上.http：//cp.literature.agilent.com/litweb ... -90005.pdf E8257D标准操作状态组寄存器位1置1时
到1表示信号发生器已经稳定到命令的最后一个状态。使用以下命令查询该寄存器：STATus：OPERation：CONDition？如果位1已设置为1，则小数值输出将为2（或小数和
所有位可以设置为1）。此信息也在Agilent Techn的第167页上
信号发生器编程指南N5180 - 90005，2009年1月.http：//cp.literature.agilent.com/litweb ... -90005.pdf第168到172页有关于注册信息的更多细节。我希望这有用 -



     以下为原文

  Hi Cengiz -

The E8257D Standard Events Status Group register bit 0 when set to a 1 signifies that the last operation commanded has been done.
Query this register with the command:  *ESR
The output of this register is the decimal value of register bits set to 1. If only bit 0 is set to a 1 then the output is decimal 1.
If bit 2 (Query Error) is set to 1 then it would output decimal 4 (or the decimal sum of all bits that may be set to 1).
This information is on page 167 of the Agilent Technologies Signal Generators Programming GuideN5180-90005, January 2009.
http://cp.literature.agilent.com/litweb ... -90005.pdf

The E8257D Standard Operation Status Group register bit 1 when set to a 1 signifies the signal generator has settled to the last state commanded.
Query this register with the command: STATus:OPERation:CONDition?
If bit 1 has been set to a 1 then the decimal value output will be 2 (or the decimal sum of all bits that may be set to 1).
This information is also on page 167 of the Agilent Technologies Signal Generators Programming GuideN5180-90005, January 2009.
http://cp.literature.agilent.com/litweb ... -90005.pdf

Pages 168 through 172 have more detail on register information.

I hope this was helpful -

感谢您的答复。
这真的很有帮助。
我将写一个关于你的答案的小应用程序.RegardsCengiz EKEN



     以下为原文

  Thank you for your response. It was really helpful. I am going to write a small application regarding your answer.
Regards
Cengiz EKEN