哪一个堆栈最适合PSOC3／5？

嗨，大家好，
我知道以太网组件的需求非常高。PSoC是这样一个伟大的芯片，它确实认为没有好的以太网解决方案。我看到这个问题在这里和PSoDeCube论坛多次出现。
是的，我们可以使用XPATH、Wiznet或任何其他模块。然而，大多数这些解决方案变得非常昂贵，如果你说的数量。
由于许多ARM控制器制造商在他们的控制器中也有以太网，所以有一个用于PSoC的以太网组件是很棒的。
我已经使用WiZnet用于我的一些项目，但是我的以太网知识并没有那么深入。我期待端口之一的开源TCP/IP栈，如UIP或LWIP。我想这不会那么困难，因为已经有很多UIP端口已经成功地完成了。
我想在讨论移植UIP，LWIP或其他任何方面…
哪一个堆栈最适合PSOC3／5？在GCC或KEIL上还有端口吗？我们可以使用像SoeSoFiver这样的存储库吗？你愿意为这样的发展做出贡献吗？我们可以使用PSoC的硬件块来实现MAC/PHY吗？还是我们仍然需要使用外部？
好了，伙计们，让我们为PSoC干杯！
当做，
罗尔夫



     以下为原文
   Hi All,
     
    I know the demand for an ethernet component is really high. PSoC is such a great chip and it really s*cks that there's no good ethernet solution for it. I see this question coming up here and on the PSoCdeveloper forum many times.
     
    Yes, we can use Xport, Wiznet or any additional module. However most of these solutions gets quite expensive if you are speaking about quantities.
     
    As many ARM controller manufacturers also have ethernet inside their controllers, it would be great to have an Ethernet Component for PSoC.
     
    I've used Wiznet for some of my projects but my ethernet knowledge not really goes that deep. I am looking to port one of the open source TCP/IP stacks like uIP or lwIP. I guess it will not be that hard as there are many uIP ports already successfully done.
     
    I'd like to make a start in discussing porting uIP, lwIP or any other....
   

     
• which stack is best suited for PSoC3/5?
• are there any ports yet done on GCC or Keil?
• can we use a repository like SourceForge?
• would you like to contribute in such development?
• can we use PSoC's hardware blocks to implement MAC/PHY or do we still have to use external?
  

     
    Okay guys, let's get this sucker done for PSoC!
     
    Regards,
    Rolf