深度待机模式下S6E1C1 SWD故障

你好，
我在定制板上使用S6E1C12B0AGP2.0，我经历了一些奇怪的行为和深度待机模式。
首先，编写了一些测试GPIOs、定时器、UART和I2C总线的基本代码。一切都很好。之后，我写了一个小项目来测试深度待机模式和测量待机电流。我把LPM组件放在顶层设计中，这个函数在主体C中调用。
LPMIGotoStistByMead（ToeStBestToMead，TRUE）；
然后，我建立和编程的目标。这很好，但是当我试图重新编程目标时，PSoC创建者无法通过SWD检测到目标。我尝试PSOC程序员也有几个配置（编程模式重置和电源周期，不同的时钟速度）。
我不知道当目标处于深度待机模式时SWD接口是否被禁用，但是当MimPrim3发送一个执行功率循环的重置时，它不应该再次启用吗？
提前感谢。



     以下为原文
  Hello,
I'm working with the S6E1C12B0AGP20000 in a custom board and I’ve experienced some strange behavior with the deep standby modes.
At first, I programmed some basic code for testing GPIOs, timers, UART and I2C bus. Everything worked fine. After that, I wrote a small project to test the deep standby modes and measure the standby current. I put the LPM component in the top design and this function call in the main.c:
Lpm_GoToStandByMode(DeepStbStopMode , TRUE);

Then I build and program the target. This worked fine, but when I tried to reprogram the target again, the PSOC creator was unable to detect the target via SWD. I tried with PSOC Programmer too with several configurations (programing mode reset and power cycle, different clock speeds).
I don’t know if the SWD interface is disable while the target is in deep standby mode, but shouldn’t it be enabled again when the miniprog3 send a reset of perform a power cycle?

Thanks in advance.