ENA E5071C放大器宏如何禁用矢量校准进行压缩？

我正在尝试使用ENA E5071C使用ENA放大器向导0141测量更高功率放大器的压缩。我看到校准存在一些问题。
宏总是强迫我执行矢量校准。
添加可以跳过矢量校准的选项是个好主意。
在大多数情况下，标量校准将足够且更快地执行。
如果你使用20到40 dB的安全衰减，它就不能完全与矢量cal一起工作。
有没有办法跳过这个？
SP。
源流平也看起来也不太好。
我有几个时间错误200.不知道它是什么测量，我只能假设它不能平衡功率。
老实说，你应该在练级过程中跳过调整源。
您应该设置任意功率（0dBm）并读取功率计上的功率，然后使用它来校准接收器。
因此参考是功率计看到的功率。



     以下为原文

  I am trying to measure compression on higher power amplifiers with ENA E5071C using ENA Amplifier wizard 0141.
I see some problem with calibration. The macro always force me to perform vector calibration. It will be good idea add option that can skip that vector calibration. In most cases scalar calibration will be sufficient and faster to perform. And if you use 20 to 40 dB safety attenuation it not exactly working with vector cal.  

Is there way to skip that?

sp. the source leveling also look not so good too. I got couple time error 200. Not sure what it meas, I can only assume that it could not level the power.

Honestly  you should skip adjusting the source during leveling. You should just set arbitrary power (0dBm) and read what ever the power is on power meter, then use that to calibrate the receiver.
So reference is what power the power meter see.