程序编译竟然出现这种情况，实在搞不了...大家一起来看看

library ieee;
use ieee.std_logic_1164.all;
use ieee.std_logic_unsigned.all;
entity mux1_8 is
   port (  
             SEL : in std_logic_vector( 3 downto 0);
         DATA_IN : in std_logic_vector( 7 downto 0) ;
           F : OUT std_logic_vector( 31 downto 0);
           P : OUT std_logic_vector( 9 downto 0));
   end mux1_8;      
architecture behav of mux1_8 is
begin
    PROCESS(SEL,DATA_IN)
      BEGIN
    IF SEL="1000" THEN
                        F(31 DOWNTO 0) <= "00000000000000000000000000000000";
                        P(9 DOWNTO 0) <= "0000000000";
        ELSIF SEL="1001" THEN
              F(7 DOWNTO 0) <= DATA_IN(7 DOWNTO 0);
        ELSIF SEL="1010" THEN
              F(15 DOWNTO 8)<= DATA_IN(7 DOWNTO 0);
        ELSIF SEL="1011" THEN
              F(23 DOWNTO 16)<= DATA_IN(7 DOWNTO 0);
        ELSIF SEL="1100" THEN
                  F(31 DOWNTO 24) <= DATA_IN(7 DOWNTO 0);                  
        ELSIF SEL="1101" THEN
                  P(7 DOWNTO 0) <= DATA_IN(7 DOWNTO 0);
        ELSIF SEL="1110" THEN
                  P(9 DOWNTO 8) <= DATA_IN(1 DOWNTO 0);          
        END IF ;
        END PROCESS;        
end;

小弟语法不好，小小的程序，编译出来就老是waring：
Warning: Latch FWORD[16]$latch has unsafe behavior
        Warning: Ports ENA and CLR on the latch are fed by the same signal SEL[0]
实在搞不懂呀，怎么能避免latch长生呀？
怎么知道 latch有没有相同的信号提供给不同端口的门闩,还有怎么删除latch呀
望FPGA大佬帮指点一下！多谢了！！