自制D1S启动卡住了是为什么？怎么改？

[    1.093076] sunxi-rfkill soc@3000000:rfkill@0: module version: v1.0.9
[    1.100338] sunxi-rfkill soc@3000000:rfkill@0: devm_pinctrl_get() failed!
[    1.107959] sunxi-rfkill soc@3000000:rfkill@0: get gpio chip_en failed
[    1.115249] sunxi-rfkill soc@3000000:rfkill@0: get gpio power_en failed
[    1.122672] sunxi-rfkill soc@3000000:rfkill@0: wlan_busnum (1)
[    1.129212] sunxi-rfkill soc@3000000:rfkill@0: Missing wlan_power.
[    1.136124] sunxi-rfkill soc@3000000:rfkill@0: wlan clock[0] (32k-fanout1)
[    1.143859] sunxi-rfkill soc@3000000:rfkill@0: wlan_regon gpio=204 assert=1
[    1.151742] sunxi-rfkill soc@3000000:rfkill@0: wlan_hostwake gpio=202 assert=1
[    1.159890] sunxi-rfkill soc@3000000:rfkill@0: wakeup source is enabled
[    1.167574] sunxi-rfkill soc@3000000:rfkill@0: Missing bt_power.
[    1.174300] sunxi-rfkill soc@3000000:rfkill@0: bt clock[0] (32k-fanout1)
[    1.181862] sunxi-rfkill soc@3000000:rfkill@0: bt_rst gpio=210 assert=0
[    1.190255] [ADDR_MGT] addr_mgt_probe: module version: v1.0.9
[    1.197980] [ADDR_MGT] addr_mgt_probe: success.
[    1.204489] libphy: Fixed MDIO Bus: probed
[    1.209167] CAN device driver interface
[    1.214593] sun8iw20-pinctrl 2000000.pinctrl: 2000000.pinctrl supply vcc-pe not found, using dummy regulator
​
使用晕哥 简单修改 哪吒d1 tina sdk 的 sys_config.fex 和 board.dts，让D1s先把Linux跑起来。 编译烧写固件后每次都卡在这里 但是用帖子里面的固件烧写可以进去 大佬们指导下