带绝缘体的真冰控制器为什么能够编程但不能调试呢？

我能用真冰对微控制器进行编程和调试（std设置）。我能用真冰+隔离器对设备进行编程。我无法用真冰+隔离器对设备进行调试。真冰输出：连接到MPLAB真冰……当前加载到真冰上的固件te Version.....01.43.35固件类型...........dsPIC33E/24ETarget电压检测目标设备dsPIC33EP128MC204。设备ID修订=0x4008以下存储区域将被编程：程序存储器：开始地址=0x0，结束地址=0x15ffconfigurationMemoryDeviceErased...ING…编程/验证完成目标设备没有准备好调试。请检查配置位设置并在继续之前对设备进行编程。这种故障最常见的原因是振荡器和/或PGC/PGD设置。现在我在说明书中看到这一点：由于复杂性和高动态电压范围，隔离器目前只对以下设备提供MCU技术支持：·一些8位设备（PIC18FXXJ）·SomE 16位设备（DSPIC33，PIC24）：所有32位设备（PIC32），因此，明显的问题是：我的设备支持吗？我不知道在哪里能找到这些信息。如果它被支持，为什么我能够编程但不调试呢？附加信息MPLAB X IDE V3.35 Windows 7DSPIC33 EP128MC204



      以下为原文

    I am able to program and debug the microcontroller with the real ice (std setup).
I am able to program the device with the real ice + isolator.
I am unable to debug the device with the real ice + isolator.

REAL ICE Output:

Connecting to MPLAB REAL ICE...

Currently loaded firmware on REAL ICE
Firmware Suite Version.....01.43.35
Firmware type..............dsPIC33E/24E

Target voltage detected
Target device dsPIC33EP128MC204 found.
Device ID Revision = 0x4008

The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x15ff
configuration memory

Device Erased...

Programming...
Programming/Verify complete
The target device is not ready for debugging. Please check your configuration bit settings and program the device before proceeding. The most common causes for this failure are oscillator and/or PGC/PGD settings.

now I see this in the instructions:

Because of the complexity and high dynamic voltage range, the isolator
currently provides MCU technology support for the following devices only:
• Some 8-bit devices (PIC18FXXJ)
• Some 16-bit devices (dsPIC33, PIC24)
• All 32-bit devices (PIC32)

So, the obvious question: Is my device supported?  I don't know where to find this information.  And if it turns out it is supported, why would i be able to program but not debug?


Additional Information
MPLAB X IDE v3.35
Windows 7
dspic33ep128mc204