如何更好地连接IDE

不好意思，我多年来一直在编程图片，我得大声说出来。这个错误对我来说总是一个痛苦！我已经跑过很多次了。在大多数情况下，这是一个微芯片问题，而且确实与我有关。我有一个原型，我已经使用pic16F很多年了（不管是什么型号，但它是18231825等）。我只使用一个PICkit3I也偶尔在pic18F上的原型，在另一个有效的板上，同样的问题（但它是14K22）我得到这个来回当我交换他们。一直以来，我打开微芯片i-p E程序（是的，另一个应用程序……IPE，集成编程Env，几个月前我从这个板上的另一个用户那里读到这个）当我得到这个错误时，我连接到它两次（注意我说过两次！）回到井手，它仍然是开放和砰砰！这一天剩下的时间都没有问题，除非你再次切换！THEGET设备ID（0x0）错误神秘地消失了，所有的工作都很好。只需连接它两次，不需要编程它或任何东西。（智商）。不知不觉中，IPE驱动程序知道如何更好地连接IDE。同样的，当去另一个芯片。



      以下为原文

    No Im sorry, I have been programming PICs for years now and I have to speak up.
This error for my use is always a pain!!
I have run across this many times. It is a microchip issue in most cases and really is with me.

I have a prototype Ive been using for years now with a pic16F (doent matter what kind, but its a 1823,1825 etc).          Im ONLY using a PICkit3
I also prototype on a pic18F once in a while on another valid board, same issue (but it is a 14K22)
I get this back and forth when I swap them. All the time.

I open up Microchips I-P-E program (Yes the other app... the IPE, Integrated programming Env, I read this from another user here on this board months ago) when I get this error, I connect to it TWICE (notice I said twice!!) and go back into the IDE which is still open and BANG!! no problems for the rest of the day or weeeeks, unless you switch again! The Target Device ID (0x0) error is mysteriously Gone, and all works fine. Just connect to it twice, no need to program it or anything. (IPE wise). Obliviously, the IPE drivers know how to connect better than the IDE. Same when going to the other chip as well.