编程18LF1320在3.6伏可以强制使用行擦除吗？

（抱歉）张贴到错误的论坛。我打算在微控制器中张贴。）我需要把我的18LF1320编程成一个电路，其中包括不能容忍超过3.6伏特的组件（RN1471）。不幸的是，18LF1320不批量擦除可靠低于4.5伏特，根据编程规范。我处于早期开发阶段，所以会有大量的擦除/程序循环一段时间。我目前正在使用一个带有MPLAB的ICD-3来进行编程。我听说一行擦除可以降低到2伏特，但我看不出有什么办法让ICD-3使用行擦除当编程。是否有另一种编程设备，我可以购买，可以强制使用行擦除？或者有办法让ICD-3做它吗？请不要建议二极管或跳线在我的PIC和电路的其余部分之间。有太多的互连，这是实际的，我想保持总电路面积尽可能小。



      以下为原文

    (Sorry - posted to the wrong forum.  I meant to post in Microcontrollers.)

I need to program my 18LF1320 in a circuit that includes components (a RN4871) that cannot tolerate more than 3.6 volts.  Unfortunately the 18LF1320 does not bulk erase reliably below 4.5 volts, according to the programming specs.  I am at the early development stage, so there will be lots of erase/program cycles for a while.

I am currently using an ICD-3 with MPLAB to do the programming.  I have heard that a Row Erase can be done down to 2.0 volts, but I don't see any way to make the ICD-3 use Row Erase when programming.  Is there another programming device I can buy that can be forced to use Row Erase?  Or is there a way to make the ICD-3 do it?  Please do not suggest diodes or jumpers between my PIC and the rest of the circuit.  There are too many interconnections for that to be practical, and I want to keep the total circuit area as small as possible.