Atmel Start启动软件来配置ATMEGA16m1似乎不支持

你好，我是新来的（长时间飞思卡尔/NXP用户），我有点迷惑：跟随Link KHTP//www. McCHIPC.COM/DeCSES/8BIT/AVR MCUS，选择“文档”选项卡，似乎合适的Atmel论坛（旁边的AvrFrAfk）就是这个。嗯，我没有发现任何章节提到Atmel和Atmel相关的东西…所以希望我在正确的位置。总之，长话短说，我正试图使用一个ATMEGA16M1，我想使用Atmel启动软件来配置它…但是似乎不支持这个微控制器。不过，我觉得这太老了，所以我想知道应该用哪条路线来配置它？我甚至尝试过ASF方式，但是我结束在一个图书馆里，这个微控制器被列为未归类的…你能给我一些建议，还是给我指出正确的方向？谢谢！



      以下为原文

    Hi there, I'm new here (long time Freescale/NXP user) and I'm a bit puzzled: following this link http://www.microchip.com/design-centers/8-bit/avr-mcus and selecting the "Documents" tab it seems that the proper Atmel forum (beside the venerable avrfreaks) is this one. Well, I didn't find any section mentioning the Atmel and Atmel-related things... so hopefully I'm in the right place. Anyway, long story short, I'm trying to use an ATMEGA16m1 and I'd like to use the Atmel Start software to configure it... but it seems that this microcontroller isn't supported. Still it seems pretty old to me, so I'm wondering which route should I take to configure it? I even tried the ASF way, but I ended in a library were this microcontroller is listed as uncategorized... Could you give me any advice or point me in the right direction?
Thanks a lot!