IPECMD无法使用PICKit 4供电

大家好，我想用一个皮卡4编程一个芯片，但iPECDM不想应用/W参数，并显示这个错误：配置被设置为目标板提供自己的电源，但没有电压检测到VDD。请确保您的目标已启动并再次尝试。连接失败。这是我的命令行（Bur181413665是我的4个序列号）：C:程序文件（x86）Microchip  MPLABXV4.15MPLABBIIPIPECMD。EX E/P12F63/F“C:TestFooDe1.HEX”/TSBR181413666/M/OL/W5I没有成功：/W/W5/W5/W5.0/W5.0/W5.0/W5.0O/W“5”请注意，我对IPE GUI没有问题。您有解决方案吗？谢谢您。



      以下为原文

    Hi everyone,

I want to program a chip with a PICKit 4 but IPECMD don't want to apply /W parameter and display this error :

The configuration is set for the target board to supply its own power but no voltage has been detected on VDD. Please ensure you have your target powered up and try again.
Connection Failed.

This is my command line (BUR181413665 is my PICKit 4 serial number) :

C:Program Files (x86)MicrochipMPLABXv4.15mplab_ipeipecmd. e x e /P12F683 /F"C:testFlowcode1.hex" /TSBUR181413665 /M /OL /W5

I tryed without success : /W /W5 -W5 /W5.0 /W5.00 /W5.000 /W5.0000 /W"5"

Please note that I have no problem with the IPE GUI.

Do you have a solution for me ?

Thank you.