完善资料让更多小伙伴认识你,还能领取20积分哦, 立即完善>
扫一扫,分享给好友
本帖最后由 一只耳朵怪 于 2018-6-21 10:24 编辑
各位好。 我使用的是4.9.28的内核,发现tisdk_am335x-evm_defconfig默认的配置文件中,配置串口是CONFIG_SERIAL_8250,而不是CONFIG_SERIAL_OMAP,那么这里为什么要配置成8250呢?8250的串口驱动是干嘛用的? |
|
相关推荐
1个回答
|
|
一般这种信息在user guide中的相关模块章节都能查到:
比如你的这个问题: The 8250 UART driver framework has been used for many years for several processors including x86. Therefore, TI plans on shifting away from omap-serial driver to the generic 8250 framework. 8250 support for OMAP devices was accepted into mainline 3.19 kernel. Currently there are two UART drivers available to the user and by default the legacy omap-serial driver is used. The current plan is to eventually make the 8250 driver the default for OMAP devices after several kernel releases to insure proper testing. However, the 8250 driver includes several features that are extremely useful for some users right now. The biggest new feature is support for DMA when using UART which significantly increases throughput and reliability while at the same time significantly decreasing CPU load. If you will be transferring alot of data via UART at a very high baud rate then it is recommend to use the 8250 driver. |
|
|
|
只有小组成员才能发言,加入小组>>
TMS320F28377D:新做了以377d为芯片的板子,上电后芯片复位引脚出现方波请问如何解决?
1897 浏览 0 评论
TPS55340通电后输入端保险丝烧断,芯片输入和GND之间短路
3647 浏览 4 评论
5031 浏览 0 评论
请问如何用DM368对RGB格式的图片数据进行编码生成JPEG格式图片?
1734 浏览 1 评论
9372 浏览 8 评论
CC3100BOOST使用CC3200lunchXL进行烧录
669浏览 2评论
714浏览 1评论
TMS320F28034: 利用C2prog通过SCI给TMS320F28034烧录程序,出现错误提示:Bootloading... failed (invalid echo)!
675浏览 1评论
求DLPC350 Programmer’s Guide User's Guide 中文版说明书
1197浏览 1评论
1772浏览 1评论
小黑屋| 手机版| Archiver| 电子发烧友 ( 湘ICP备2023018690号 )
GMT+8, 2024-4-24 17:02 , Processed in 0.643802 second(s), Total 76, Slave 60 queries .
Powered by 电子发烧友网
© 2015 bbs.elecfans.com
关注我们的微信
下载发烧友APP
电子发烧友观察
版权所有 © 湖南华秋数字科技有限公司
电子发烧友 (电路图) 湘公网安备 43011202000918 号 电信与信息服务业务经营许可证:合字B2-20210191 工商网监 湘ICP备2023018690号