怎么使用E8361C网络分析仪测量S11参数

您好，对于我的硕士论文，我使用了E8361C网络分析仪和N4373C光波分量分析仪来测量激光二极管的电光频率响应。
现在我需要使用E8361C网络分析仪测量S11参数。
由于我还没有这方面的测量经验，我阅读了手册，现在我希望有人可以验证我的方法：1）要获得“真正的”设备参数，我必须校准电缆和探头2）最简单的方法
这是使用SmartCal使用1端口反射校准3）对于校准向导过程，我需要一个带有LOAD，OPEN，SHORT的校准基板4）成功校准后，测量的S11参数（或多或少）是真实设备参数
这是我测量的方式。
我很满意每一个建议。
最好的祝福！



     以下为原文

  Hello,

for my Master thesis I used a E8361C Network Analyzer and a N4373C Lightwave Component Analyzer to measure the electro-optical frequency response for laser diodes.

Now I need to measure the S11 parameters with the E8361C Network Analyzer. Since I have no experience with this measurement yet, I read the manual and now I was hoping someone can validate my approach:

1) To get the "real" device paramters I have to calibrate the cables and probe head
2) The easiest way to do this is using a 1-port Reflection calibration using SmartCal
3) For the calibration wizard process I need a calibration substrate with LOAD, OPEN, SHORT
4) After successful calibrating, the measured S11 parameters are (more or less) the real device parameters

This is the way I would take for the measurements. I am happy about every suggestion.

Best regards!