怎么使用N5746A进行遥感

电源通过定制电缆连接到我们正在建造的控制台中的机箱。有用于载流引线的单独电线和用于远程连接的双绞线屏蔽线，连接到+ S和-S端子的电缆，
在初始检验和软件开发过程中，我将电源编程为28 VDC，具有适当的电流，OVP等限制，使用20欧姆功率电阻作为测试负载。无意中，电阻仅连接到电流引线
电源接通时，电源上电并将电阻器正确驱动至1.4安培。根据手册，供电应该抛出错误并关闭。
我需要发送一个软件配置来启用遥感吗？是否有内部备用连接（电阻或二极管）来防止开路感应引线错误？谢谢！戴夫



     以下为原文

  The power supply is wired with a custom cable to a chassis in the console we are building.
There are separate wires for the current carrying leads and a twisted-shielded pair for remote, sense wired to the +S and -S terminals, with the factory jumpers removed.
During initial checkout and software development, I programmed the supply to 28 VDC with appropriate current, OVP, etc. limits, with a 20 Ohm power resistor as a test load.

Inadvertently, the resistor was connected only to the current leads, and the remote sense leads were left open.
Contrary to expectations, when Output ON was sent, the supply powered up and drove the resistor correctly to 1.4 Amps.

According to the manual , the supply should have thrown an error and shut down.

Is there a software configuration I need to send to enable remote sensing?
Is there an internal back-up connection (resistors or diodes) to prevent open-sense lead errors?

Thanks!

Dave