赢7
惠普台式机RP5800
在BIOS中启用了Raid
RST版本
12.9.0.1001
选项Rom 10.1.0.1008
Bios Ver。
2.28（最新）
（2）500 GB。
SATA非会员
系统驱动器PORT 0,4个分区，最后有11 GB空闲
第二个驱动器PORT 1空白
我已经阅读了RST用户指南，我相信我对Raid Ready第7.2节有所有要求
我已经阅读了很多关于此的帖子，主要说明驱动器上需要有一些可用空间，但仍然无法显示CREATE按钮。
系统驱动器去年已成像，但安装程序未在安装映像之前将驱动器设置为成员。
驱动器上有大量数据，需要几个小时才能获得新的当前映像，将驱动器重置为成员并重新映像。
该网站是24小时。
高容量的餐厅，我们正在努力减少停机时间。
以上来自于谷歌翻译
以下为原文
Win 7
HP Desktop RP5800
Raid enabled in bios
RST ver. 12.9.0.1001
Op
tion Rom 10.1.0.1008
Bios Ver. 2.28 ( latest)
( 2 ) 500 GB. SATA Non Member
System drive PORT 0, 4 partitions, has 11 GB free at end
Second drive PORT 1 blank
I have read the RST User guide, I believe I have all requirements for Raid Ready Section 7.2
I have read many posts about this, mainly stating that there needs to have some free space on the drive, but still cannot get the CREATE button to display.
The system drive was imaged last year, but the installer did not set the drives as Members before installing the image. There is a lot of data on the drives and would take a few hours to obtain a new current image reset the drives to members and reimage. The site is a 24 hr. high volume restaurant and we are trying to minimize downtime.
举报
