怎么在CY8CKIT-059 Kitprog板上加载自定义固件

嗨，Simone，
是的，可以将定制固件加载到CY8CKIT-059的KiTrg侧。
详情请参阅第7节开发KoPro用户指南的PSoC 5LP应用程序。



     以下为原文
  Hi Simone,
 
Yes, It is possible to load custom firmware on to the KitProg side of the CY8CKIT-059.
Please refer to section 7 Developing Applications for PSoC 5LP of KitProg User Guide for details.

谢谢，现在我找到了你提到的那一部分！然而，我尝试遵循“BootloadLead”方式在设备上闪动我的应用程序，但是当它在Bootloader状态（绿色状态LED闪烁）时，Bootloader主机工具似乎找不到设备。在KiPrg正常模式下，该工具被注意到。



     以下为原文
  Thank you, now I found the section you mentioned! However I'm trying to follow the "Bootloadable" way to flash my application on device but when it is on Bootloader status (green status led is blinking) Bootloader Host Tool doesn't seem to find the device. On Kitprog normal mode the device is noticed by the tool.

请尝试在Bootloader主机工具（如KITPROG用户指南的图7-10所示，当工具包处于Bootloader模式）中显示Sub USB设备选项，这将列出工具包。



     以下为原文
  Please try enabling the Show USB Devices option in Port Filter dialog in the Bootloader Host tool (as shown in Figure 7-10 of the KitProg User Guide, when the kit is in bootloader mode), that will list the kit.

对不起，我在跟踪KITPRO2用户指南！现在我看了正确的文件，一切都正常了！
谢谢！



     以下为原文
  I'm sorry I was following KitProg2 User Guide! Now I looked at the right document, and everything worked!
Thanks!