完善资料让更多小伙伴认识你,还能领取20积分哦, 立即完善>
嗨,我正在尝试使用ST1CC40构建一个恒流LED驱动器。我构建了一个原型版本,注意到没有连接负载,输出端会看到整个Vin(在我的情况下是12V)。这是正常的吗?假设Vout应为5V且Vin为12V,当INH引脚拉低时,Vout将接近零。然而,当INH拉高时,Vout会在稳定之前在Vin和Vout之间摆动吗?换句话说,Vout会出现大幅飙升吗?
#st1cc40 以上来自于谷歌翻译 以下为原文 Hi, I'm trying to build a constant current LED driver using the ST1CC40. I built a prototype version and noticed that with no load attached, the entire Vin (in my case its 12V) is seen at the output. Is this normal? In a situation where lets say the Vout is supposed to be 5V and the Vin is 12V, when the INH pin is pulled low, the Vout would be close to zero. However, when the INH is pulled high, would the Vout swing between Vin and Vout before stabilizing? In other words, would there be a massive spike in Vout? #st1cc40 |
|
相关推荐
1个回答
|
|
|
|
|
|
只有小组成员才能发言,加入小组>>
请教:在使用UDE STK时,单片机使用SPC560D30L1,在配置文件怎么设置或选择?里面只有SPC560D40的选项
1453 浏览 1 评论
2120 浏览 1 评论
请问是否有通过UART连接的两个微处理器之间实现双向值交换的方法?
1510 浏览 1 评论
2825 浏览 6 评论
5244 浏览 21 评论
362浏览 4评论
540浏览 4评论
在Linux上安装Atollic TRUEStudio的步骤有哪些呢?
279浏览 3评论
使用DMA激活某些外设会以导致外设无法工作的方式生成代码是怎么回事
610浏览 3评论
513浏览 3评论
小黑屋| 手机版| Archiver| 电子发烧友 ( 湘ICP备2023018690号 )
GMT+8, 2024-4-24 19:44 , Processed in 5.858628 second(s), Total 94, Slave 78 queries .
Powered by 电子发烧友网
© 2015 bbs.elecfans.com
关注我们的微信
下载发烧友APP
电子发烧友观察
版权所有 © 湖南华秋数字科技有限公司
电子发烧友 (电路图) 湘公网安备 43011202000918 号 电信与信息服务业务经营许可证:合字B2-20210191 工商网监 湘ICP备2023018690号